There is a lot of dust in the working process of the stone engraving machine. Some users will think that the stone engraving machine itself is a machine used in dust, and it is very troublesome to clean it every day. Therefore, many people not only do not clean up, but also allow the machine to be full of things, which will seriously affect the performance and normal work of the stone engraving machine.
Several aspects of stone engraving machine inspection and cleaning:
1) Check and clean up the computer of the stone engraving machine
Computer abnormality will also cause many problems, especially the computer connected to the engraving machine, it is necessary to regularly check the computer and clean up viruses and computer space.
1. Regularly check and kill viruses, but pay attention not to open the anti-virus level during work, which will cause interference.
2. Regularly clean the dust of the chassis, pay attention to the heat dissipation of the chassis, and be careful that too much dust may cause errors in the industrial control card.
3. Regularly defragment the disk and optimize the computer system.
2) Inspection and cleaning of mechanical parts of stone engraving machine
1. Regularly clean the industrial control box.
2. Regularly clean the guide rail to prevent foreign objects from sticking to the track. The track is very important in the equipment, it determines the accuracy of the machine, and the track also plays an important role in the transmission process. The machine is equipped with a special dust cover to remove dust and dust. Better results.
3. After the engraving work is completed, the countertop should be cleaned in time, which provides convenience for the next work of the stone engraving machine.
4. Clean the guide rail and the dust and debris beside the guide rail to prevent the machine from jamming during the working process due to the interference of debris.
3) The treatment of stone carving oil pollution and waste oil
The maintenance and maintenance of the stone engraving machine should add lubricating oil in time. After adding oil, move back and forth at a slow speed. CAD drawing ensures that the lubricating oil can be evenly added to the guide rail and the lead screw.
After the machine is not used for a long time, it is best to use a cloth (without depilation) to clean up the oil stains, waste oil and material chips on the guide rail and the lead screw to ensure the flexibility of the operation of the components.
4) Check and clean the water in the stone engraving machine
1. When the stone engraving machine is not in use, if the room temperature is low, it is best to pour out the water in the water tank to prevent the water tank and water pipes from freezing and cracking.
2. Clean and replace the water in the spindle motor and water pump in time every week to ensure that the water is clean; especially when the equipment is not used in winter, the cooling water of the spindle must be cleaned in time to prevent the spindle from being damaged by low temperature freezing, delaying normal use and causing unnecessary losses.
3. Pay attention to the water level, and never make the water-cooled spindle motor lack water, so that the motor heat cannot be exported in time.